- Capable of turning stationary shafts up to 8”
Hydratight Portable Lathe
Climax 30” Milling Machine
- 30” long x 12” wide in any position
Climax 60” Milling Machine
- 60” of travel and 30” width of cut
108 Milling Machine
- Capable of milling surfaces of up to 108” long and 30” wide. Also capable of drilling and boring holes up to 6” in any position.
BB4000 Climax Boring Machine with 1.75” Diameter Bar
- Capable of boring multiple in-line bores from 1.875” to 10”
BB5000 Climax Boring Machine with 2.25” Diameter Bar
- Capable of boring multiple in-line bores from 3.5” to 15”
BB6000 Climax Boring Machine with 3.5” Diameter Bar
- Capable of boring multiple in-line bores from 5” to 37” bore size capacity. With facing attachment, cam face from 10.5” to 37”.
BB8000 Climax Boring Machine with 6” DIameter Bar
- Can bore from 13.5“ to 81.5”, with facing capabilities from 13.5“ to 81.5”
Mirage Flange Facer
- Bore mounted flange facer, 6” to 40” diameter capacity with a boring depth of 4”
Climax Flange Facer 5000
- Bore mounted flange facer 5” to 24” capacity.
Climax Flange Facer 6100
- Bore mounted flange facer 14” to 60” capacity.
Climax Flange Facer 8000
- Bore mounted flange facer 30” to 120” capacity. Machine can be fitted to mount on ODs from 30” to 109”
MIT Clamshell Pipe Cutter
- Cuts and J-grooves pipes up to 12”. Faces diameters from 6” to 12″
Slugger Magnetic Drill 2x2
- Cuts and J-grooves pipes up to 12”. Faces diameters from 6” to 12”
Slugger Magnetic Drill 4x4
- Cuts and J-grooves pipes up to 12”. Faces diameters from 6” to 12”
Lamina Hydraulic Drills
- Can drill holes up to 4”, 18.1875” deep and tap holes up to 3.625”. All sizes of heads.
We offer technical support of removal, repair and installation of equipment including a full range of on-site machining, coupling and shaft alignment.
Drilling and tapping
- Counter bores, stud removal and tapping capacities up to 3.625”
- Bore plug removal and installation
Milling
- Motor, pump and miscellaneous bases
- Gasket and sealing surfaces
- Keyways in shafts
Turning
- Shaft ODs
- Heater and cooler faces
- Flange faces from 6” to 120” diameters
Line Boring
- Bearing fits, seal bores
- 1.875” to 72” diameter bores
- Gear Boxes
All machines above are property of Progress Pump. Additional equipment to expand our capabilities is available.
Field Services
- Open, Clean and Close
- Machining
- Balancing
- Laser Alignment
- Vibration Analysis
- Portable Machine Shop with Light Duty Machining
Parts, new and repaired
- Blades (Repair & Manufacture)
- Seals (Repair & Manufacture)
- Bearings
- Hardware
- Seal Strips
Shop Services
- Reblading/Spindle and Cylinder Halves
- Machining
- Balancing
- Control, Governor, Throttle Valves
- Servo Motor
- Turning Gear
- Bearing and Thrust Bearings
- Repairs to Turbine Auxilary Equipment including Oil Pumps, Evactors, and Heat Exchangers
CONTACT INFORMATION
